Format Sd Memory Card - ETC SmartFade User Manual

L o a d s h o w f r o m c a r d
This is done from the Save/Load Show menu
Menu>Save/Load Show>[Load show]
Select the show with the wheel. Confirm loading by pressing MENU.The default show
offered for loading will be the last show, or the lowest numbered recording on the card.
L o a d p a t c h f r o m c a r d
This is done from the Save/Load Show menu.
Menu>Save/Load Show>[Save as]
Select the show with the wheel. Confirm loading by pressing MENU.
The default show offered for loading a patch from will be the lowest numbered recording on
the card. The reason for this is that you may want to save a dummy show with just a patch
as show 01.
F o r m a t S D M e m o r y C a r d
SD and SDHC Memory cards are usually pre-formatted. You may need to reformat your
card(s) so that they will function with the console. SmartFade supports the following formats
on SD and SDHC cards:
• SD Memory cards : FAT16 only
• SDHC Memory cards : FAT16 or FAT32 only
Formatting has to be done in a PC. You will need an SD card reading device connected to
your PC.
C A U T I O N :
Formatting your SD Card will erase any information stored on the card. Be sure to
remove any important files from the card before formatting.
C A U T I O N :
Only standard SD Memory cards or connection to a PC via USB may be used for
updating the software on a SmartFade console. Software update is not possible
using an SDHC Memory card.
Step 1: Insert the SD card into its reading device. Make sure the device is connected to
your Windows PC.
Introduction 7