R e c o r d a S e q u e n c e
Action
1. Activate record
sequence
2. Choose location
(change page if desired)
3. If desired, set the time
for this step
4. Select source for this
step
5. End recording
Test sequence
Press CLEAR three times to clear all intensities. The light in the bump button of the fader
will be dimmed in yellow to show that it has a sequence stored. It lights up at full if the fader
is above zero and contributing to the output. Select MEMS mode and move the fader for
the recorded sequence up. The sequence you recorded should appear on stage.
3
Program
Console
REC
SEQ
...
or
21
24
...
45
48
Wheel
...
or
1
24
...
1
48
REC
SEQ
Feedback
All buttons that can record in this mode will
blink at full in yellow. If there is a memory or
sequence stored already, this button will be
dimmed (press CLEAR to exit).
The moment the bump button is pressed, the
console will switch back into the previous
fader mode. All bump buttons that can be
used will blink at full.
You can select any memory or intensity
channel. Change fader page if desired.
When a bump button is pressed, that memory
or intensity will be stored as a step with the
times set in the wheels.
Repeat steps 3-4 until satisfied.
End recording. The console will return to the
fader mode prior to recording this sequence.
Press UNDO to undo this recording.
37
Need help?
Do you have a question about the SmartFade and is the answer not in the manual?
Questions and answers