Memories; Record A Memory - ETC SmartFade User Manual

Memories

Every intensity can be stored to a memory for playback.
There are 12 fader pages with 24 (48) memory faders in each page. This provides a
possible total of 288 memories in a SmartFade 1248/1296 and 576 memories in a
SmartFade 2496.
A recorded memory is indicated in red. The bump button lights up at full if the fader is above
zero, contributing to the light output.
To select Memories mode for the faders press MEMS.
MEMS
The current fader page 1-12 is indicated in the bump buttons during a second when MEMS
is pressed. You can hold MEMS to verify this and to change fader page.
R e c o r d a m e m o r y
Set up a look you want to record using the channel faders. You may record the output from
other memory faders as well.
Action
1. Activate recording
2. If needed, change page
3. Select fader
Test memory
Press CLEAR four times to clear all intensities. Select MEMS mode. The light in the bump
button of the fader will be dimmed to show that it has content. Move the fader up. The same
look you recorded should appear on stage.
32
Console
REC
MEM
...
1 12
MEMS
... or
1 24
...
1 48
Feedback
Buttons that can record in this mode will blink
at full. If there is a memory stored already,
this button is dimmed (press CLEAR to exit).
If needed, hold MEMS and press a bump
button 1-12 to change page.
The moment the bump button is pressed, the
memory is stored and the console will auto-
matically return to it's previous fader mode.
Press UNDO to undo this recording.
SmartFade v3.0.1 User Manual