NetCol5000-A(025, 035) In-row Air Cooled Smart
Cooling Product
User Manual (600 mm)
Figure 3-51 Position and cable routing out of the unit
Setting the DIP Switch on the Humidity and Temperature Sensor
Figure 3-52
Figure 3-52 DIP switch
You need to set the DIP switch to change the communications address of sensors.
describes the operation description.
Issue 13 (2019-01-15)
A humidity and temperature sensor should be installed 1.5 m above the floor.
Each smart cooling product supports three cold aisle humidity and temperature sensors and three hot
aisle humidity and temperature sensors at most.
shows the DIP switch on a humidity and temperature sensor.
Copyright © Huawei Technologies Co., Ltd.
3 Installation Guide
Table 3-17
75