Huawei NetCol5000-A User Manual page 212

NetCol5000-A(025, 035) In-row Air Cooled Smart
Cooling Product
User Manual (600 mm)
Figure 6-19 Replacing the humidifier cylinder
Step 4 Loosen the belt around the humidifier cylinder and remove the cylinder, as shown by (2) and
(3) in
Step 5 Open the rubber pad on the cable port, and clear the glue on the port using a flat-head
screwdriver, as shown by (4) in
Step 6 Remove the screws from the electrode cable connection terminals above the humidifier
cylinder using the 10# socket wrench, remove the cable connection terminals, and remove the
cable from the high water level sensor, as shown by (5) in
Step 7 Install a new humidifier cylinder by performing
the humidifier.
When replacing the humidifier cylinder, you do not need to apply glue to the cable connection port
again.
Step 8 Power on the humidifier, choose Maint > Diagnostic mode on the main menu, and enter
100%. The water is injected to the humidifier. Check whether the humidifier works properly.
If yes, exit the diagnostic mode.
Step 9 Drain the water from the humidifier cylinder by following the instructions provided in
Issue 13 (2019-01-15)
Figure 6-19.
Copyright © Huawei Technologies Co., Ltd.
Figure 6-19.
Step 3 to
6 System Operation and Maintenance
Figure 6-19.
Step 6 in the reverse order, and start
Step 1.
203