Cisco ASA Series Cli Configuration Manual page 1543

Chapter 1 Configuring the ASA CSC Module
Detailed Steps
Command
Step 1
hw-module module 1 recover configure
Example:
hostname# hw-module module 1 recover
configure
Image URL [tftp://127.0.0.1/myimage]:
tftp://10.1.1.1/ids-newimg
Port IP Address [127.0.0.2]: 10.1.2.10
Port Mask [255.255.255.254]: 255.255.255.0
Gateway IP Address [1.1.2.10]: 10.1.2.254
VLAN ID [0]: 100
Step 2
hw-module module 1 recover boot
Example:
hostname# hw-module module 1 recover boot
Step 3
show module 1 details
Example:
hostname# show module 1 details
Resetting the Password
You can reset the module password to the default. The default password is cisco. After resetting the
password, you should change it to a unique value using the module application.
Resetting the module password causes the module to reboot. Services are not available while the module
is rebooting.
Purpose
Specifies the location of the new image. This command prompts
you for the URL for the TFTP server, the management interface
IP address and netmask, gateway address, and VLAN ID (ASA
5505 only). These network parameters are configured in
ROMMON; the network parameters you configured in the module
application configuration are not available to ROMMON, so you
must set them separately here.
You can view the recovery configuration using the show module
1 recover command.
In multiple context mode, enter this command in the system
execution space.
Transfers the image from the TFTP server to the module and
restarts the module.
Checks the progress of the image transfer and module restart
process.
The Status field in the output indicates the operational status of
the module. A module operating normally shows a status of "Up."
While the ASA transfers an application image to the module, the
Status field in the output reads "Recover." When the ASA
completes the image transfer and restarts the module, the newly
transferred image is running.
Cisco ASA Series CLI Configuration Guide
Troubleshooting the CSC Module
1-15