Cisco ASA Series Cli Configuration Manual page 1519

Chapter 1 Configuring the ASA CX Module
Shutting Down the Module
If you restart the ASA, the module is not automatically restarted. To shut down the module, perform the
following steps at the ASA CLI.
Detailed Steps
Command
hw-module module 1 shutdown
Example:
hostname# hw-module module 1 shutdown
Monitoring the ASA CX Module
•
•
•
•
•
Note
For ASA CX-related syslog messages, see the syslog messages guide. ASA CX syslog messages start
with message number 429001.
Showing Module Status
To check the status of a module, enter one of the following commands:
Command
show module
show module 1 details
Examples
The following is sample output from the show module command for an ASA with an ASA CX SSP
installed:
hostname# show module
Mod Card Type
--- -------------------------------------------- ------------------ -----------
0 ASA 5585-X Security Services Processor-10 wi ASA5585-SSP-10
1 ASA 5585-X CX Security Services Processor-10 ASA5585-SSP-CX10
Mod MAC Address Range
Purpose
Shuts down the module.
Showing Module Status, page 1-15
Showing Module Statistics, page 1-16
Monitoring Module Connections, page 1-17
Capturing Module Traffic, page 1-20
Debugging the Module, page 1-20
Purpose
Displays the status.
Displays additional status information.
Model
Hw Version Fw Version
Cisco ASA Series CLI Configuration Guide
Monitoring the ASA CX Module
Serial No.
JAF1507AMKE
JAF1510BLSA
Sw Version
1-15