Cisco ASA Series Cli Configuration Manual page 1480

Information About the ASA IPS module
Figure 1-3
Figure 1-4
traffic flow goes to a different sensor.
Figure 1-4
Information About Management Access
You can manage the IPS application using the following methods:
•
•
Cisco ASA Series CLI Configuration Guide
1-4
Security Contexts and Virtual Sensors
Main System
Context
1
Context
Sensor
1
IPS
shows a single mode ASA paired with multiple virtual sensors (in inline mode); each defined
Single Mode ASA with Multiple Virtual Sensors
Main System
Sensor
1
IPS
Sessioning to the module from the ASA—If you have CLI access to the ASA, then you can session
to the module and access the module CLI. See the
on page 1-11.
Connecting to the IPS management interface using ASDM or SSH—After you launch ASDM from
the ASA, your management station connects to the module management interface to configure the
IPS application. For SSH, you can access the module CLI directly on the module management
interface. (Telnet access requires additional configuration in the module application). The module
management interface can also be used for sending syslog messages or allowing updates for the
module application, such as signature database updates.
ASA
2
Context
3
Sensor
2
ASA
Traffic 1
Traffic 2
Traffic 3
Sensor Sensor
2 3
"Sessioning to the Module from the ASA" section
Chapter 1 Configuring the ASA IPS Module