Configuring Sntp - Hirschmann Power MICE User Manual

Synchronizing the System Time of the

7.2.3 Configuring SNTP

V Select the Time:SNTP dialog.
Configuration SNTP Client and Server
U
V In this frame you Switch the SNTP function on/off.
When it is switched off,
the SNTP server does not send any SNTP packages and does
not reply to any SNTP requests.
The SNTP client does not send any SNTP requests and does not
interpret any broadcast/multicast packages.
SNTP-Status
U
D
The "Status message" displays conditions such as "Server cannot
be reached".
Configuration SNTP Server
U
V In "Anycast destination address" you enter the IP address to
which the SNTP server on the Switch sends the SNTP packages.
IP target address
0.0.0.0
Unicast
224.0.1.1
255.255.255.255
Table 4: Periodic sending of SNTP packages
V In "VLAN ID" you specify the VLAN to which the Switch may
periodically send SNTP packages.
V In "Anycast send interval" you specify the interval at which the
Switch sends SNTP packages (valid entries: 1 second to 3600 se-
conds, default: 120 seconds).
108
Send SNTP
packages periodically
to
Nobody
Unicast
Multicast
Broadcast
7.2 SNTP
Basic - L3P
Release 3.1 06/07