Configuring Ports - Hirschmann Power MICE User Manual

Configuring ports

5 Configuring ports
The port configuration consists of:
D
Switching the port on and off,
D
Selecting the operation mode,
D
Displaying connection error messages,
D
Configuring Power over Ethernet.
Switching the port on and off
U
In the state on delivery, all ports are switched on. To enhance access
security, switch off the ports which you do not wish to connect..
V Select the Basics:Port Configuration dialog..
V Select in the "Port on" column the ports which are connected to a
device.
Selecting the Operation Mode
U
In the state on delivery, all ports are switched to the "Automatic Configu-
ration" mode.
V Select the Basics:Port Configuration Table dialog.
V If the device connected to this port requires a fixed setting
– select the operation mode (transmission rate, duplex operation) in
the "Manual Configuration" colimn, and
– deactivate the port in the "Autonegotiation" column.
Note: The active automatic configuration has priority over the manual
configuration.
Basic - L3P
Release 3.1 06/07
69