Introduction To Parameters; Parameter Types; Parameter Lists; General Parameters, Description - Reliance electric GV3000/SE Instruction Manual

Introduction to Parameters

The GV3000/SE software allows access to many parameters that are adjustable by using the keypad.
The factory preset values will suit a wide range of applications. To configure the controller for a specific
application, you must bring up each appropriate parameter on the display and adjust as necessary.
This Section 4 provides the description and detailed information necessary for designing applications for
commonly used P.xxx parameters for both V/Hz and Vector modes. Indicated default values are the
European type (Refer to P.049, Country Defaults).
Section 8 provides a complete lists of available parameters, and their European type factory preset
values. It also provides space to check off, or enter values as they are modified for record keeping.

Parameter Types

There are three types of parameters:
• • • • Configurable: These parameters can only be adjusted or changed while the drive is stopped.
• • • • Tunable: These parameters can be adjusted or changed while the drive is running or stopped.
• • • •
Read only: These output variables are read only, cannot be adjusted.
Each parameter is described in detail. The following information is provided for each parameter:
Parameter Number: The unique number assigned to a specific parameter. The number is
preceded by either P, H, U or r to identify it as a General, Volts/Hertz, Vector or optional RMI
parameter, respectively. The parameter number is displayed on the drive's keypad/display.
Parameter Name: The name assigned to a parameter number. The parameter name is not
displayed when programming drive using the keypad/display. The parameter name is only visible
when using the CS3000 software or Operator Interface Module (OIM).
Parameter Description: A description of the parameter's function.
Parameter Range: The pre-defined parameter value limits or selections.
Default Setting: The factory default setting.
Parameter Type: Identifies whether the parameter is Tunable, configurable, or read only.
Refer also to parameters: A list of associated parameters that may provide additional or related
information.

Parameter Lists

Various types of parameter lists are foreseen for 2 different regulation types and optional equipment.
'P.xxx' : General Parameters, commonly used for both types the V/Hz and Vector regulation.
They range from
P.000 to P.006 in a 'Short List' or 'First Menu', accessible to the operator, and
P.007 to P.099 in a 'Long List' or 'Second Menu', available via password entering into P.006.
P.051 can be used to disable/enable parameter programming as a safety feature.
Toggling of programming enabling/disabling is available via password entering.
'H.xxx' : V/Hz Mode Parameters, (range: H.000 to H.022) available via password entering into P.006.
'U.xxx' : Vector Mode Parameters, (U.000 through U.048) available via password entering into P.006.
These parameters are used only for vector applications and are displayed if UEC is selected in
parameter P.048. Unless specified, all vector parameters are used for both flux vector control
(FVC) and sensorless vector control (SVC) operation.
'r.xxx' RMI option parameters, (range: r.001 to r.066) available if RMI option card is connected via
password entering into P.006. Refer to RMI-Manual 49'1330.
For parameter verification and programming, and password entry refer to Section 3 of this manual.
It is the users responsibility to determine how to distribute the Second Menu password.
Rockwell Automation is not responsible for unauthorized password access violations within the user's
organization. Failure to observe this precaution could result in bodily injury.
49'1329 e

4 - GENERAL PARAMETERS, DESCRIPTION

WARNING
GV3000/SE 4 - 1