Jog Speed Reference; Jog Ramp Acceleration Time; Jog Ramp Deceleration Time - Reliance electric GV3000/SE Instruction Manual

P.020

Jog Speed Reference

Parameter Range: Minimum Speed (P.003) to Maximum Speed (P.004)
Initial Setting: V/Hz mode:
Vector mode:
Type: Tunable (at rest or during operation)
Refer to: P.003 Minimum Speed
P.004 Maximum Speed
Description: Jog speed is activated while continuously asserting the START input from the
selected control source and jog mode has been selected.
Jogging can be accomplished from either a local or remote control source. Jog
speed is independent of any other speed reference. Jog speed cannot be changed
with the UP/DOWN arrow keys or remotely while the drive is in run mode.
P.021

Jog Ramp Acceleration Time

Parameter Range: 1.0 - 999.9 seconds (V/Hz)
0.1 - 999.9 seconds (Vector)
Initial Setting: 20.0 (20 seconds)
Type: Tunable (at rest or during operation)
Refer to: P.004 Maximum Speed
U.017 Motor Top Speed
Description: For volts/hertz regulation, this parameter specifies the amount of time (seconds) it
takes the motor to ramp from zero speed to Maximum Speed (P.004) in jog mode.
For vector regulation, this parameter specifies the amount of time (seconds) it takes
the motor to ramp from zero speed to Motor Top Speed (U.017) in jog mode.
The time the motor takes to make any speed decrease is directly proportional to the
value in this parameter.
P.022

Jog Ramp Deceleration Time

Parameter Range: 1.0 - 999.9 seconds (V/Hz)
0.1 - 999.9 seconds (Vector)
Initial Setting: 20.0 (20 seconds)
Type: Tunable (at rest or during operation)
Refer to: P.004 Maximum Speed
P.025 Stop Type
U.017 Motor Top Speed
Description: For volts/hertz regulation, this parameter specifies the amount of time (seconds) it
takes the motor to ramp from Maximum Speed (P.004) to zero speed in jog mode.
For vector regulation, this parameter specifies the amount of time (seconds) it takes
the motor to ramp from Motor Top Speed (U.017) to zero speed in jog mode.
The time the motor takes to make any speed decrease (except a coast-to-rest stop)
is directly proportional to the value in this parameter.
4 - 18
4 - GENERAL PARAMETERS, DESCRIPTION
5 Hz
150 RPM
GV3000/SE 49'1329 e