Programming Enable / Disable; To Disable Programming On Local Keypad; To Enable Programming - Reliance electric GV3000/SE Instruction Manual

Programming Enable / Disable

Programming of parameters can be disabled by accessing Parameter P.051 "Programming Disable".
Note: Similar to a hardware ON/OFF switch, you need to repeat the following steps to then "re-enable"
programming. If the display indicates 'LU' fault, the programming of parameters is inhibited.

To Disable Programming on Local Keypad:

Action
1. Follow instructions for "To View or Change
Parameters in Second Menu List"
2. Access 'P.051' on the display.
3. Press ENTER key.
Press keys ⇑ or ⇓, until value '0026' is
4.
displayed.
5. Press ENTER key to enter value.

To Enable Programming:

1. As above !
to
4.
5. Press ENTER key to enter value.
49'1329 e
3 - USING THE GV3000/SE KEYPAD/DISPLAY
GV3000/SE
Display / Notes
LED 'Password' :
OFF = Programming Enabled,
ON = Programming Disabled.
Displays shows 'P.051'.
Displays shows value '0' of 'P.051'
Displays shows value '0026' of 'P.051'
Displays shows 'P.051'. LED 'Password' :
ON = Programming Disabled. The ability to
change parameter values has been disabled.
As above !
Displays shows 'P.051'. LED 'PASSWORD' :
OFF = Programming Enabled. The ability to
change parameter values has been enabled.
3 - 5