Program Mode; To View Or Change Parameters In The First Menu List; To View Or Change Parameters In The Second Menu List - Reliance electric GV3000/SE Instruction Manual

Program Mode

To View or Change Parameters in the First Menu List (General Parameters P.000 - P.006)
Action
1. To enter PROGRAM mode:
Press the PROGRAM key
If the display does not show 'P.---', move the ⇑
2.
or ⇓ key until it does.
3. Press the ENTER key.
Press ⇑ or ⇓ key to move through the first
4.
menu list containing parameters P.000 - P.006.
5. Once the desired parameter is displayed, press
the ENTER key.
Press the ⇑ key to increase the value, or the ⇓
6.
key to decrease the value.
7. Press the ENTER key to enter the value.
(or go to 9. to leave the old value)
8. Go to the next parameter number, and so on.
9. Press the PROGRAM key, to exit the
PROGRAM mode.
To View or Change Parameters in the Second Menu List (General Parameters P.007-P.099)
In order to access the "Second Menu General Parameter List" or H... at V-Hz, resp. U... at Vector, or
r... with RMI, you must go to P.006 "Second Menu Password Value" and enter your password value:
1. To Enter the Password for Second Menu
List: Start as described above. Call up P.006.
2. Press the ENTER key.
Press ⇑ or ⇓ key until display shows Second
3.
Menu Enable password value '0107'.
4. Press the ENTER key to enter the value.
5. Press PROGRAM key.
Press ⇑ or ⇓ key to select either 'P.---' or 'H.---'
or 'U.---' (or 'r---') param. list or error log 'Err'.
6. Press the ENTER key to select requested
parameter list.
7. Press PROGRAM key, to exit PROGRAM
mode.
3 - 4
3 - USING THE GV3000/SE KEYPAD/DISPLAY
GV3000/SE
Display / Notes
Display shows 'P.---' (or the last active parameter
group or 'Err") and the PROGRAM LED is lit.
Display shows 'P.000', first parameter number in
"First Menu General Parameter List".
⇑ key: Display shows 'P.000', 'P.001' etc.
Display shows the parameter "value".
Note: The value will not be retained into memory
unless the ENTER key has been pressed.
The PROGRAM LED goes OFF.
PROGRAM LED is ON.
Display shows 'P.006'
Display shows value '0' of P.006.
Display shows '0107'. (Holding down the ⇑ or ⇓
key will increase scroll speed).
Password has been entered. Display: 'P.006'.
Display shows selectable parameter list 'P.---' or
'H.---' or 'U.---' (or 'r---') or error log 'Err'.
Display shows parameter '_.000' of selected
group or error log 'Err'.
The PROGRAM LED goes OFF.
49'1329 e