Overview; Commands At Control Source Local; Layout Of The Keypad / Display - Reliance electric GV3000/SE Instruction Manual

Overview

The operator's station KEYPAD is an user's tool to
Display various drive status and technical data (as frequency, voltage, current, power, etc.),
Program parameter values, either viewing only, or changing values,
Fault handling, either clearing faults or looking at error log,
Control drive via buttons START, STOP/RESET, RUN/JOG, FORWARD/REVERSE,
AUTO/MANUAL, FASTER/SLOWER.
The KEYPAD is factory mounted in the inverter.
External mounting for example in a control desk is not supported.
. . . .
RPM
RUN
V
REM
A
JOG
Hz
AUTO
kW
FWD
TRQ
REV
PASS
PROG
STOP
START
RESET
FWD
AUTO
MAN
REV
RUN
PROG
JOG
ENTER
Type 003-030, 039/044
Fig. 3-1: Layout of the Keypad / Display

Commands at control source LOCAL:

NOTE: In the following description the designations of the keys and LED's are related to the Keypad of
inverters 038/043 and 058-360. On the Keypad for inverters 003-030, 039/044 some designations are in
short form.
The drive's keypad has nine (9) membrane keys that are used to monitor, program, and control the drive.
1. Stops drive, regardless of selected control source (P.000) LOCAL, REMOTE, or
STOP
RESET
2. Resets fault, after cause has been removed.
Important: The STOP/RESET key can be disabled by P.055. See the P.055 parameter description for
more information.
49'1329 e
3 - USING THE GV3000/SE KEYPAD/DISPLAY
STOP
RESET
Type 038/043 and 058-360
other future sources.
Refer to P.025 for STOP Type ('Coast-to-rest' or 'Controlled Stop')
GV3000/SE
. . .
RUNNING
SPEED
REMOTE
VOLTS
AMPS JOG
AUTO
Hz
kW FORWARD
REVERSE
TORQUE
Password PROGRAM
START
.
AUTO Forward
MAN Reverse
RUN
PROGRAM
JOG
R
ENTE
3 - 1