Ventilation Of The Spray Booth; Air Supplies - WAGNER GM 5000EAC Operating Manual

EDITION 03/2012
OPERATING MANUAL
The GM 5000EAC spray gun must be used a part of an electrostatic spraying system
(Spraypack). The spraying system shown in the fi gure B_03158 is only one example of an
electrostatic spraying system. Contact your Wagner distributor for assistance in designing
a system to meet your needs. The operating instructions and the safety regulations for the
additional system components used must be read before starting-up.
Incorrect installation/operation!
Risk of injury and damage to equipment
SIHI_0050_GB
5.1.2

VENTILATION OF THE SPRAY BOOTH

Toxic and/or flammable vapor mixtures!
Risk of poisoning and burns
SIHI_0028_GB
5.1.3

AIR SUPPLIES

The use of an air fi lter with the air pressure regulator (6) ensures that only dry, clean
atomizing air gets into the spray gun. Dirt and moisture in the atomizing air reduce the
spraying quality and the appearance of the fi nished piece.
PART NUMBER DOC 2319150
When putting into operation and for all work, read and follow
the operating instructions and safety regulations for the additionally
required system components.
WARNING
Operate the unit in a spraying booth approved for the working
materials.
-or-
Operate the unit on an appropriate spraying wall with the
ventilation (extraction) switched on.
Observe national and local regulations for the outgoing air
speed.
WARNING
GM 5000EAC.
23