Spreader Controls - Toro 34215 Operator's Manual

Note:
When parking on a steep slope, chock or block
the wheels in addition to engaging the parking brake.
When transporting the machine, engage the parking
brake and bind the machine to the transport vehicle.
Drive-Wheel-Release Lever
The drive-wheel-release lever is located above the
platform on the left side
Use the drive-wheel-release lever to disengage the
hydrostatic-drive system to move the machine by
hand.
•
To push or pull the machine, move the
drive-wheel-release lever up.
•
To operate the machine, move the
drive-wheel-release lever down.

Spreader Controls

Deflector Gate Control
The deflector-gate control is located to the right of the
hour meter on the control console
1. Deflector-gate control
2. Spreader-pattern control
3. Wide-distribution
impeller-gate lever
4. Narrow-distribution
impeller-gate lever
Use the deflector-gate control to temporarily stop
the discharge of granular materials from the left side
of the spreader. Close the deflector gate with the
control when it is not desirable to broadcast granular
materials onto sidewalks, parking lots, or patios.
(Figure 9).
(Figure 10).
Figure 10
5. Narrow-spreader
distribution flow-rate
knob
6. Impeller On/Off switch
7. Impeller-speed control
•
Push the knob for the deflector-gate control down
to close the gate and temporarily deflect the
granular materials.
•
Pull the knob up to open the deflector gate for full
granular broadcasting.
Spreader-Pattern Control
The spreader-pattern control is located to the right
of the deflector-gate control at the control console
(Figure 10).
Use the spreader-pattern control to broadcast a
heavier pattern of granular material to the left or right
side of the machine.
•
To broadcast a heavier pattern to the left, unlock
the spreader-pattern control, pull the control up
slightly, and lock the control.
•
To broadcast a heavier pattern to the right, unlock
the spreader-pattern control, push the control
down slightly, and lock the control.
Wide-distribution Impeller-Gate Lever
The wide-distribution impeller-gate lever is the fourth
lever located at the top center of the control console
(Figure 10).
•
To broadcast a wide pattern of granular material,
pull the wide-distribution impeller-gate lever
rearward fully to the full open position.
•
To close the impeller gate, push the
wide-distribution impeller-gate lever forward full
closed position.
Narrow-distribution Impeller-Gate Lever
The narrow-distribution impeller-gate lever is the fifth
lever located at the top center of the control console
(Figure 10).
•
To broadcast a narrow pattern of granular material,
pull the narrow-distribution impeller-gate lever
rearward fully to the limited O
•
To close the impeller gate, push the
wide-distribution impeller-gate lever forward fully.
g033347
Note:
Only the wide-distribution impeller-gate
lever closes the impeller gate. Pushing the
wide-distribution impeller-gate lever forward also
resets the narrow-distribution impeller-gate lever
to the forward position.
Narrow-Spreader Distribution Flow-Rate Knob
The narrow-spreader distribution flow-rate knob is
located below the wide- and narrow-impeller-gate
levers (Figure
Use the narrow-spreader distribution-flow-rate knob to
control the discharge rate of granular material from the
hopper onto the impeller when the narrow-distribution
impeller-gate lever is in the O
13
PEN
10).
position (limited).
PEN
position.