Spreader Controls - Toro 34215 Operator's Manual

Fuel-Shut-Off Valve
The fuel-shut-off valve is located at the front, right side of the
engine below the fuel tank
Note: Close the fuel-shut-off valve when the machine is not
used for a few days, during transport to and from the job site,
or when the machine is parked inside a building.
1. Fuel-shut-off valve (right side of the engine)
Parking-Brake Lever
The parking-brake lever is located above the platform on the
right side (Figure 10).
•
To set the parking brake, push the parking-brake lever
down.
Note: The brake lever engages a parking brake in the
transaxle.
•
To release the parking brake, pull the lever up.
1. Drive-wheel-release lever
2. Platform
(Figure 9).
Figure 9
Figure 10
3. Park-brake lever
Note: When parking on a steep slope, chock or block
the wheels in addition to setting the parking brake. When
transporting the machine, set the parking brake and bind the
machine to the transport vehicle.
Drive-Wheel-Release Lever
The drive-wheel-release lever is located above the platform
on the left side (Figure
Use the drive-wheel-release lever to disengage the
hydrostatic-drive system to move the machine by hand.
•
To push or pull the machine, move the drive-wheel-release
lever up.
•
To operate the machine, move the drive-wheel-release
lever down.

Spreader Controls

Deflector Gate Control
The deflector-gate control is located to the right of the hour
meter on the control console
1. Deflector-gate control
2. Spreader-pattern control
3. Wide-distribution
impeller-gate lever
4. Narrow-distribution
impeller-gate lever
Use the deflector-gate control to temporarily stop the
discharge of granular materials from the left side of the
spreader. Close the deflector gate with the control when it is
not desirable to broadcast granular materials onto sidewalks,
parking lots, or patios.
16
10).
(Figure 11).
Figure 11
5. Narrow-spreader
distribution flow-rate
knob
6. Impeller On/Off switch
7. Impeller-speed control