Toro 34215 Operator's Manual page 20

Sprayer and Spreader Operation
Safety
•
The spray wand traps liquids under high pressure,
even when engine is off. High-pressure spray
could cause serious injury or death.
– Keep clear of nozzle and do not direct spray
or stream at people, pets, or non-work area
property.
– Do not direct spray on or near electrical-power
components or source.
– Do not attach hoses or other components to
the end of the spray-wand nozzle.
– Do not attempt to disconnect the spray
wand from the machine while the system is
pressurized.
– Do not use spray wand if trigger lock is
damaged or missing.
– Rotate the spray-wand lock to the O
when job is complete.
•
Do not touch the impeller for the spreader while
the impeller is rotating.
•
Stop spreading/spraying when making tight turns
to minimize chemical drift.
•
Chemicals may drift and cause injury to people
and animals; it may also damage plants, soil, or
other property.
•
Liquid loads and granular materials can shift. This
shifting happens most often while turning, going
up or down hills, suddenly changing speeds, or
while driving over rough surfaces. Shifting loads
can cause the machine to tip over.
•
Safely relieve pressure from spray wand every
time the engine is shut off.
•
When draining or relieving system, do not let
anyone stand in front of nozzles and do not drain
on a person's feet.
Slope Safety
Slopes are a major factor related to loss of control and
rollover accidents, which can result in severe injury or
death. You are responsible for safe slope operation.
Operating the machine on any slope requires extra
caution.
•
Review the slope instructions listed below for
operating the machine on slopes and to determine
whether you can operate the machine in the
conditions on that day and at that job site.
Changes in the terrain can result in a change in
slope operation for the machine.
•
Determine if the slope is safe for machine
operation, including surveying the site. Always
use common sense and good judgment when
performing this survey.
•
Avoid starting, stopping, or turning the machine
on slopes. Travel up and down on slopes. Avoid
making sudden changes in speed or direction.
If you must turn the machine, turn it slowly and
gradually downhill, if possible. Use care when
reversing the machine.
•
Do not operate a machine when you are uncertain
about the traction, steering, or stability.
•
Remove or mark obstructions such as ditches,
holes, ruts, bumps, rocks, or other hidden hazards.
Tall grass can hide obstructions. Uneven terrain
could overturn the machine.
•
Be aware that operating the machine on wet
surfaces, across slopes, or downhill may cause
the machine to lose traction. Loss of traction to the
wheels may result in sliding and a loss of braking
and steering.
position
FF
•
Use extreme caution when operating the machine
near drop-offs, ditches, embankments, water
hazards, or other hazards. The machine could
suddenly roll over if a wheel goes over the edge
or the edge caves in. Establish a safety area
between the machine and any hazard.
•
Use extra care while operating the machine with
attachments; they can affect the stability of the
machine.
•
If the engine stalls or you begin to lose momentum
while climbing a hill, gradually apply the brakes
and slowly back straight down the hill.
•
Always keep the transmission in gear (if applicable)
when you drive the machine down a slope.
•
Do not park the machine on an incline.
•
The weight of the material in the tank can change
the handling of the machine. To avoid loss of
control and personal injury, follow these guidelines:
– When operating with a heavy load, reduce your
speed and allow for sufficient braking distance.
Do not suddenly apply the brakes. Use extra
caution on slopes.
– Liquid loads shift, especially while turning,
going up or down slopes, suddenly changing
speeds, or while driving over rough surfaces.
Shifting loads can cause the machine to tip
over.
20