Storage; Preparing The Machine For Extended Or Winter Storage - Toro 34215 Operator's Manual

Disposing of the Battery
DANGER
Battery electrolyte contains sulfuric acid,
which is poisonous and can cause severe
burns. Swallowing electrolyte can be fatal or
if it touches skin can cause severe burns.
• Wear eye protection to shield eyes, and
rubber gloves to protect skin and clothing
when handling electrolyte.
• Do not swallow electrolyte.
• In the event of an accident, flush with water
and call a doctor immediately.
Federal law states that batteries should not be placed
in the garbage. Management and disposal practices
for batteries must follow relevant federal, state, or
local laws.
Take the battery to a local certified-recycling center
if you replace a worn or damaged battery or if the
machine no longer operates and is being scrapped.
Note:
If no local recycling is available, return the
battery to any certified battery seller.

Storage

1. Set sprayer-pump switch to the O
stop the machine, move motion-control lever to
the N position, shut off the engine, wait
EUTRAL
for all moving parts to stop, remove key, and
engage parking brake.
2. Remove dirt and grime from the entire machine.
Important:
You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use
of water, especially near the engine and
hydrostatic drive.
3. Service the air cleaner; refer to
Cleaner (page
4. Lubricate the machine; refer to
Grease Fittings (page
5. Change the engine oil; refer to
Engine Oil (page
6. Remove the rear wheels, apply a copper-based,
anti-seizing compound to the rear-axle shafts,
and install the wheels; refer to
Bolts (page 63).
7. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
8. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
9. Store the machine in a clean, dry garage or
storage area.
10. Cover the machine to protect it and keep it clean.
Preparing the Machine for
Extended or Winter Storage
To help protect the pumps from freezing temperatures,
ensure that the unit is free of all caustic chemicals
and residue.
Cleaning the Spreader
Perform all the steps in
Spreader (page 43).
Winterizing the Sprayer
Emptying the Tank
1. Perform all the steps in
System and Wand (page
Strainer (page
Nozzle (page
2. Empty the sprayer system by performing the
following:
69
FF
Servicing the Air
51).
Lubricating the
51).
Changing the
53).
Torquing the Axle
Cleaning and Lubricating the
Cleaning the Sprayer
44), Cleaning the
45), and Cleaning the Sprayer
45).
position,