Engine Controls; Spreader Controls - Toro Spray Master Series Operator's Manual

Engine Controls

1. Throttle control
2. Choke control
Ignition Switch
The ignition switch is located at the left side of the
control console (Figure
Use the ignition switch to start and run, or shut off the
engine. The ignition switch has 3 positions: S
R and S .
UN TART
Note:
You must engage the parking brake to start
the engine.
Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
position (Figure 9).
Choke Control
Use the choke control to start a cold engine.
Hour Meter
The hour meter displays the total hours of engine
operation. The hour meter
whenever you rotate the key switch to the O
or if the engine is running.
Figure 9
3. Hour meter
4. Ignition switch
9).
to F
LOW
(Figure 9) starts to function
N

Spreader Controls

1. Impeller-speed control
2. Deflector control
g317354
Impeller-Speed Control
Use the impeller-speed control
speed of the hydraulic motor for the spreader.
Hopper-Door Control
The hopper-door control
the door inside the base of the hopper
Deflector Control
,
TOP
The deflector control
into the spreader pattern.
Diffuser Control
The diffuser control
placement of the impeller either to the edge of the
impeller or to the middle of the impeller.
AST
position
14
Figure 10
3. Diffuser control
4. Hopper-door control
(Figure 10) to set the
(Figure 10) opens and closes
(Figure 10) pivots the deflector
(Figure 10) shifts the product
g317353