Table of Contents
Advertisement
Preparing the Machine when
Spraying in the Manual Mode
1.
Fill the sprayer tank and fresh water tank; refer
to filling the spray tank and filling the fresh-water
tank procedures in the Operator's Manual.
2.
As needed, configure the following optional
settings:
•
Optional: If you are using the
, enter the volume of chemical in
INDICATOR
the sprayer tank; refer to
Volume (page
•
Optional: set the low limit indicator and the
low limit volume value for the tank; refer to
Setting the Low Limit Indicator (page 6)
Setting the Low Limit Volume Value (page
1. Master section-switch
indicator—O
N
2. Right section indicator—O
3. Target-application rate (gpa
shown)
4. System-pressure indicator
(psi shown)
LOW LIMIT
Setting the Tank
6).
5. Tank-volume indicator (US
gallons shown)
6. Rinse-system
N
indicator—O
(optional
N
kit)
7. Agitation indicator—O
8. Spray-pump indicator—O
Product Overview
Controls
InfoCenter Home Screen
When you start the machine, the home screen
appears, displaying the corresponding icons that
apply (i.e., the parking brake is engaged, the sprayer
sections are on, you are out of the seat, etc.).
Note:
The following figure is an example screen;
this screen shows all the potential icons that could
appear on the screen while operating.
and
Refer to the following graphic for all of the icon
7).
definitions
(Figure
Figure 1
9. Active-application
rate/boost-rate
indicator—O
N
10. Operator out of seat
11. Parking-brake indicator
N
12. Vehicle-speed indicator
N
(mph shown)
2
1).
13. Active-application rate (gpa
shown)
14. Center section
indicator—O
N
15. Left section indicator—O
g191986
FF
Advertisement
Table of Contents
