Controls - Toro Multi-Pro 1250 Operator's Manual

Controls

1. Steering wheel
2. Spray-Pro monitor
3. Speed limiter
Accelerator Pedal
The accelerator pedal (Figure 11) gives you the ability to
vary ground speed of the sprayer. Pressing the pedal
increases ground speed. Releasing the pedal will slow
the sprayer and the engine will idle.
1. Brake pedal
Brake Pedal
Use the brake pedal to stop or slow the sprayer
(Figure 11).
4. Choke
5. Sprayer controls
6. Rate lockout switch
Figure 11
2. Accelerator pedal
Figure 10
7. Parking brake
8. Master boom foot switch
9. Range Selector
CAUTION
Brakes can become worn or can be adjusted
incorrectly resulting in personal injury.
If brake pedal travels to within 1 inch (2.5 cm) of the
sprayer floor board, the brakes must be adjusted
or repaired.
Parking Brake
The parking brake is a large lever to the right of the seat.
(Figure 12). Engage the parking brake whenever you
plan on leaving the seat to prevent accidental movement
of the sprayer. To engage the parking brake, pull up and
back on the lever. To disengage, push it forward and
down. If the sprayer is parked on a steep grade, apply
the parking brake and place blocks at the downhill side
of the wheels.
17
10. Voltmeter
11. Hour meter
12. Vehicle controls