Operating The Machine - Toro 34215 Operator's Manual

Operating the Machine

Extending and Retracting the
Operator's Platform
Extending the Operator's Platform
1. Pull the platform-lock knob inward until the pin of
clears the upper hole in the chassis
Figure 17
1. Platform-lock knob
2. Operator's platform
2. Rotate the operator's platform down until the pin
of the platform lock aligns with the lower hole in
the chassis (Figure
3. Move the platform-lock knob outward until the
pin protrudes through the lower hole
Retracting the Operator's Platform
1. Pull the platform-lock knob inward until the pin
clears the upper hole in the chassis
2. Rotate the operator's platform up until the pin of
the platform lock aligns with the upper hole in
the chassis (Figure
3. Move the platform-lock knob outward until the
pin protrudes through the upper hole
(Figure
3. Lower chassis hole
17).
(Figure
(Figure
17).
(Figure
Opening and Closing the
Fuel-Shut-Off Valve
Control fuel flow to the engine with the fuel-shut-off
valve as follows:
•
Rotate the handle for the fuel-shut-off valve 90
degrees clockwise to the open the valve.
•
Rotate fuel-shut-off valve handle 90 degrees
counterclockwise to close the valve.
17).
g027430
1. Fuel tank
2. Fuel-shutoff valve (open
position)
Starting the Engine
1. Ensure that the fuel-shutoff valve is open; refer
17).
to Opening and Closing the Fuel-Shut-Off Valve
(page 21).
2. Move the steering-control/motion-control
lever in N
parking brake; refer to
17).
11), Motion-Control Lever (page
Parking-Brake Lever (page
Note:
To start the engine, you must engage the
parking brake. (You can start the engine while
you are off the platform.)
17).
3. Move the throttle lever midway between the
S and F
LOW
Control (page
21
Figure 18
3. Fuel-shutoff valve (closed
position)
position and engage the
EUTRAL
Steering Control (page
12).
positions; refer to
AST
12).
g027146
11), and
Throttle