Engine Controls; Spreader Controls - Toro Spray Master Operator's Manual

Caster Wheel-Lock Pedal
•
Press and hold the caster wheel-lock pedal
6) to lock the caster wheels in the straight position.
•
Release the caster wheel-lock pedal to unlock the
caster wheels, and allow the machine to freely
turn.
1. Brake foot pedal (parking
brake)
Parking Brakes
•
Push the left and right brake foot-pedals
down to engage the brakes.
•
Push the left and right brake foot-pedals up to
disengage the parking brakes.

Engine Controls

1. Throttle control
2. Choke control
3. Hour meter
Figure 6
2. Caster-lock pedal
(Figure
Figure 7
4. Operator-presence
switch/lanyard
5. Ignition switch
Ignition Switch
(Figure
The ignition switch is located at the left side of the
control console
Use the ignition switch to start and run, or shut off the
engine. The ignition switch has 3 positions: S
R and S
UN TART
Note:
You must engage the parking brake to start
the engine.
Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
position (Figure
Choke Control
Use the choke control to start a cold engine.
g311617
Operator-Presence Switch/Lanyard
Pulling the lanyard from the operator-presence switch
(Figure 7) shuts off the engine.
Hour Meter
The hour meter displays the total hours of engine
operation. The hour meter
6)
whenever you rotate the key switch to the O
or if the engine is running.

Spreader Controls

1. Impeller-speed control
2. Deflector control
Impeller-Speed Control
g311614
Use the impeller-speed control
speed of the hydraulic motor for the spreader.
Hopper-Door Control
The hopper-door control
the door inside the base of the hopper
14
(Figure 7).
.
7).
(Figure 7) starts to function
Figure 8
3. Diffuser control
4. Hopper-door control
(Figure
(Figure 8) opens and closes
,
TOP
to F
LOW AST
position
N
g311623
8) to set the