Care And Maintenance - CARDIOSTRONG TX90 Assembly And Operating Instructions Manual

2.3

Care and maintenance

The most important maintenance measure is taking care of the running belt. This includes the
adjustment, tensioning and lubrication of the running belt. Damage caused due to a lack of care or
negligence will not be covered by the warranty. Thus, check for maintenance in regular intervals. Be
extremely careful when adjusting and tightening the belt, because a strong over or under tension
may lead to damage. The running mat is set properly in the factory before delivery. However, the
running mat may get out of place during transport.
Adjustment of the running mat
+ During training, the running belt should run as centered and straight as possible. The alignment
of the running belt may change depending on the stress and load. Another reason can be the
positioning of the equipment on an uneven surface.
+ While adjusting the belt, let the equipment run with a speed of approximately 5km/h. Nobody
may be on the equipment during this process.
+ If the running belt drifts off to the left, turn the left setting screw on the rear end of the equipment
at most 1/4 rotation clockwise and the right setting screw at most 1/4 rotation counterclockwise
(fig. C).
+ If the running belt drifts off to the right, turn the right setting screw on the rear end of the
equipment at most 1/4 rotation clockwise and the left setting screw at most 1/4 rotation
counterclockwise (fig. D).
+ Then watch how the belt runs for approximately 30 seconds, because the change will not be
visible immediately.
+ Repeat the process until the running belt runs straight again. If the running mat cannot be
adjusted, please contact the contract partner.
Move the belt to the right
Fig.: C
Move the belt to the left
Fig.: D
11