Troubleshooting, Care And Maintenance; General Instructions; Faults And Fault Diagnosis - CARDIOSTRONG TX-50 Assembly And Operating Instructions Manual

5

TROUBLESHOOTING, CARE AND MAINTENANCE

5.1

General Instructions

⚠ WARNING
+ Do not make any improper changes to the equipment.
CAUTION
⚠
+ Damaged or worn components may affect your safety and the life of the equipment.
Therefore, immediately replace damaged or worn components. In such a case, contact the
contract partner. The equipment must not be used until it has been repaired. If necessary, use
only original spare parts.
ड ATTENTION
+ In addition to the instructions and recommendations for maintenance and care given here,
additional service and/or repair work may be necessary; this must only be carried out by
authorised service technicians.
5.2

Faults and Fault Diagnosis

The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually sufficient. Please refer to the following overview for the most common errors and
how to correct them. If the equipment still does not function properly, contact your contract partner.
Fault
Console only shows
lines
Running belt tilted
Running belt slips
through/stops
Scraping noises
Display does not
show anything
No pulse display
34
Cause
Safety key missing
Running belt not aligned
Belt tension/lubrication
not ok
Running belt scrapes,
because it is not aligned
Check plug connections
(cables)
+ Sources of interference in
the room
With chest strap
+ Unsuitable chest strap
+ Position of the chest
strap incorrect
+ Batteries empty
Solution
Check if the safety key is inserted and
place it in
Align running belt in accordance with
the instructions
Check belt tension/lubrication in
accordance with the instructions
Align running belt in accordance with
the instructions
Mains switch on "on", make sure that the
safety key is inserted
+ Remove sources of interference (e. g.
mobile phone, speakers, etc.)
+ Use suitable chest
recommended accessories)
+ Reposition chest
moisten electrodes
+ Change batteries
strap (see
strap and/or
TX50