Care And Maintenance - CARDIOSTRONG CST-TR20-2 Assembly And Operating Instructions Manual

For more information, please visit cardiostrong.com, sport-tiedje.com

Hide thumbs

Table Of Contents

Table of Contents

Error

code

N/A

The LED on the start button glows faintly, other LEDs are not on: The machine is in power

saving mode. Hold the START button for one second.

N/A

The console display is fluctuating or does not light up: Check if the treadmill is correctly

connected to the power supply. Turn the power switch off and back on. Safety key is plug-

ged in. Check all cable connections for correct connection. If the problem is still occurring,

please contact customer service.

N/A

The belt does not run in the middle during usage:

First check if the treadmill has a stable position, then follow the operating manual in regards

to tension and adjusting the belt (the deck).

N/A

The motor appears to be overloaded or E1 appears after a few minutes of training:

The silicone applied to the deck and belt has dried out and the deck must be lubricated

again with silicone spray.

N/A

The running mat slips during usage. The belt must be tensioned after a certain amount

of usage. Follow the belt tensioning and alignment in this manual.

N/A

Heart rate fluctuates or is not recorded:

Check to see if your hands are moist, if all connections behind the console are correct and if

any cables are damaged. With a chest strap, check the battery status and make sure that all

electrodes are moist and correctly placed below the chest.

N/A

Silicone symbol is illuminated on the console:

Lubricate the machine with 100% pure silicone. Then press speed down and START at the

same time until the symbol goes out.

2.4