Door And Hinges - Maytag MXR65 Service Manual

1. The door is attached to the washer with two
hinges. To remove the door, remove two of
the three T-30 bolts in the top hinge.
2. Remove three T-30 bolts from bottom hinge.
3. Support the door and remove the last bolt
from the top hinge.
4. Remove the door. There are notches in the
door frame that the hinges fit into.

DOOR aND HiNGeS

Two T-30
Bolts
Two T-30
Bolts
Hinge
Notches
3-38
5. There may be shims between the hinges
and the door for proper alignment and door
closing pressure. Make sure the shims are
reinstalled as they were found. The shims
mount on posts on the hinge.
6. Pull the hinge blocks off the hinge pins.
7. To remove the hinge blocks from the
washer, remove two T-30 bolts from each
hinge block.
NOTe: The hinge block bolts are longer
than the door to hinge bolts.
TeCH TiP: When reinstalling these bolts,
use thread lock on the first 1/8" to 1/4" of the
threads.
Door To
Hinge Bolt
Hinge
Block Bolt