Chemical Dispenser Lid And Gasket - Maytag MXR65 Service Manual

CHeMiCal DiSPeNSeR liD aND GaSkeT

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Open the top panel. (See page 3-1)
2. The chemical dispenser lid can be removed,
by pulling the long hinge pin out, with a pair
of pliers.
3. To remove the chemical dispenser outer
gasket, lift up at the edge and peel the
gasket away from the edge of the dispenser.
4. The cutouts on the back edge of the gasket
5. When reinstalling the gasket, the chemical
6. Remove two T-20 screws from the front
Hinge Pin
7. Lift the front edge of the dispenser and slide
8. Make sure the gasket is wrapped under the
3-19
are for the lid hinges.
dispenser will at least need to be lifted to
allow the gasket to be wrapped under the
edge of the dispenser frame.
edge of the dispenser frame.
Two T-20
Screws
it forward to release the two tabs at the
back edge of the dispenser, and allow the
dispenser to be lifted.
edge of the dispenser all the way around
the dispenser.
Gasket
Wrapped
Dispenser
Edge