Motor Drive Pulley; Motor Switch; Mixing Valve; Tub Cover And Gasket - Maytag NAV2330 Service Manual

Disassembly Procedures
!
NOTE: Lay motor on its side. Observe belt configuration
around rear pump leg. Belt MUST encircle rear
pump leg when reassembling.
2. Remove nut, washer, and bolt securing idler lever and
pulley to motor mounting bracket.
3. Apply a light film of No. 03637P Lubricant to area of
idler lever that makes contact with motor mounting
bracket.
NOTE: DO NOT OVER LUBRICATE! Excess lubricant
can be thrown into pivot dome area during normal
washer operation. Any lubricant on the pivot
dome, base or friction ring will affect washer
operation.
4. Reverse procedure to reassemble.

Motor Drive Pulley

1. Remove idler lever and pulley steps 1–3, see "Idler
Lever and Pulley" procedure.
2. Lay motor assembly on its side.
NOTE: To remove pulley, support motor shaft (to prevent
bending shaft) and drive out pulley roll pin.
3. Reverse procedure to reassemble.

Motor Switch

1. Remove front panel, see "Front Panel" procedure.
2. Remove screws securing motor shield to motor.
3. Disconnect wire harness from motor switch. Press
down on locking tab connection block and at the
same time, pull connection block away from motor
switch.
!
CAUTION
To avoid risk of an open circuit, DO NOT pull on
terminal block wires when removing block from motor
switch as this could damage wires or connection
crimpings. Before attaching wire harness connection
block to motor switch, verify all male terminals on
motor switch are straight and are capable of accepting
terminals from wire harness connection block.
©2005 Maytag Services
WARNING
16022937 Rev. 0
To avoid risk of electrical shock, personal injury, or
death, disconnect power to unit before servicing.
Switch attaching
screws
Locking
tab
Connection
block
4. Remove screw securing motor switch to motor and
remove switch.
5. Disconnect internal motor leads from motor switch
terminals.
NOTE: See appropriate wiring diagram when rewiring
components.

Mixing Valve

1. Disconnect water inlet hoses.
2. Remove screw securing mixing valve bracket.
3. Pull mixing valve bracket and valve out the back of
washer.
4. Disconnect quick disconnect terminals from mixing
valve solenoid terminals.
NOTE: See appropriate wiring diagram when rewiring
components.
5. Reverse procedure to reassemble.

Tub Cover and Gasket

1. There are eight tub cover hold-down tabs which snap
over the outer tub flange. Push downward on tub
cover, this will release the tension on the hold-down
tab on the tub cover. Pull out on the flap and at the
same time lift upward on cover to unsnap hold-down
tabs from outer tub flange. One by one, disengage
each of the eight hold-down tabs from outer tub flange
and remove cover.
2. Remove tub cover from outer tub and remove old
gasket from tub cover.
NOTE: When installing outer tub cover, always use a
new cover gasket.
NOTE: Clean and remove any foreign material in gasket
groove of outer tub cover and outer tub flange.
Motor
switch
29