Outer Tub & Bearing Support - Maytag MXR65 Service Manual

OuTeR TuB & BeaRiNG SuPPORT
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove the top panel. (See page 3-16)
2. Remove both side panels of the washer.
(See page 3-56) (See page 3-58)
3. Remove the T-20 screw, just behind the
chemical dispenser, securing the front end
of the center support brace.
4. Remove the T-20 screw from the top back
frame rail and remove center support brace.
5. Slide control panel and chemical dispenser
assembly toward the back of the outer tub.
6. Allow the top back panel to rest on the floor.
7. Lower the control panel assembly. The
hoses will fold between the front and back
components.
8. Loosen the 7mm hose clamp securing the
chemical inlet hose to the back of the outer
tub. Pull the hose off.
3-64
7mm Hose
Clamp