Store/Ld) Load; Utility; Utility:) Set-Rtc (Set Real-Time Clock) - Comtech EF Data CRS-311 Installation And Operation Manual

CRS-311 1:1 Redundancy Switch
Front Panel Operation
5.2.5.2

(STORE/LD) LOAD

LOAD CONFIGURATION FROM
LOCATION: 10
Use the▲▼arrow keys to select the location from which to load (recall) a configuration, and
then press ENTER.
Locations 1 through 10 are available. If the selected location contains valid data, the choice is
confirmed as follows:
THE NEW CONFIGURATION
HAS BEEN LOADED
Press ENTER or CLEAR to return to the previous menu. If, however, the selected location does
not contain valid data, you are alerted to this state as follows:
WARNING! LOC 10 CONTAINS
NO DATA!
Press ENTER or CLEAR to return to the previous menu.

5.2.6 UTILITY

UTILITY: SET-RTC DISPLAY
SW-ID TYPE
Use the ◄►arrow keys to select SET‐RTC, DISPLAY, SW‐ID, or INDEP‐MODE, and then press
ENTER.
While selectable, TYPE is intended for CEFD internal (factory) test / diagnostic use only
and provides no functional user purpose.
5.2.6.1

(UTILITY:) SET-RTC (Set Real-Time Clock)

EDIT REAL TIME CLOCK:
12:00:00 24/04/00
To edit the time and date settings of the real‐time clock, first use the ◄►arrow keys to select
the digit to edit, and then use the ▲▼arrow keys to change the value of that digit. Press
ENTER when done.
Note that, in accordance with international convention, the date is shown in DAY‐MONTH‐YEAR
format.
(ENTER)
(ENTER)
(ENTER)
INDEP-MODE
(ENT)
5–18
Revision 7
MN/CRS311.IOM