Cisco MDS 9000 Series Configuration Manual page 80

Configuring a Zone Using the Zone Configuration Tool
Figure 14: Create Zone Dialog Box
Step 4 Enter a zone name.
Step 5
Check one of the following check boxes:
1. Read Only—The zone permits read and denies write.
2. Permit QoS traffic with Priority—You set the priority from the drop-down menu.
3. Restrict Broadcast Frames to Zone Members
Step 6 Click OK to create the zone.
If you want to move this zone into an existing zone set, skip to Step 8.
Step 7 Click Zoneset in the left pane and click the Insert icon to create a zone set.
You see the Zoneset Name dialog box (see
Figure 15: Zoneset Name Dialog Box
Step 8
Enter a zone set name and click OK .
Note One of these symbols ($, -, ^, _) or all alphanumeric characters are supported. In interop mode 2 and 3, this
symbol (_) or all alphanumeric characters are supported.
Step 9 Select the zone set where you want to add a zone and click the Insert icon or you can drag and drop Zone3 over
Zoneset1.
You see the Select Zone dialog box (see
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
58
Figure 15: Zoneset Name Dialog Box, on page
Figure 16: Select Zone Dialog Box, on page
Configuring and Managing Zones
58).
59).