Configuring Interop Mode 1 - Cisco MDS 9000 Series Configuration Manual

Advanced Features and Concepts

Configuring Interop Mode 1

commandsTo verify the resulting status of issuing the interoperability command in any switch in the Cisco
MDS 9000 Family, follow these steps:
SUMMARY STEPS
1. Use the show version command to verify the version.
2. Use the show interface brief command to verify if the interface states are as required by your configuration.
3. Use the show run command to verify if you are running the desired configuration.
4. Use the show vsan command to verify if the interoperability mode is active.
5. Use the show fcdomain vsan command to verify the domain ID.
6. Use the show fcdomain domain-list vsan command to verify the local principal switch status.
7. Use the show fspf internal route vsan command to verify the next hop and destination for the switch.
8. Use the show fcns data vsan command to verify the name server information.
DETAILED STEPS
Step 1 Use the show version command to verify the version.
switch# show version
Cisco Storage Area Networking Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2003, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
Cisco Systems, Inc. and/or other third parties and are used and
distributed under license. Some parts of this software are covered
under the GNU Public License. A copy of the license is available
at http://www.gnu.org/licenses/gpl.html.
Software
BIOS: version 1.0.8
loader: version 1.1(2)
kickstart: version 2.0(1) [build 2.0(0.6)] [gdb]
system: version 2.0(1) [build 2.0(0.6)] [gdb]
BIOS compile time:
kickstart image file is: bootflash:///m9500-sf1ek9-kickstart-mzg.2.0.0.6.bin
kickstart compile time:
system image file is:
system compile time:
Hardware
RAM 1024584 kB
bootflash: 1000944 blocks (block size 512b)
slot0:
172.22.92.181 uptime is 0 days 2 hours 18 minute(s) 1 second(s)
Last reset at 970069 usecs after Tue Sep 16 22:31:25 1980
Reason: Reset Requested by CLI command reload
System version: 2.0(0.6)
Service:
Step 2
Use the show interface brief command to verify if the interface states are as required by your configuration.
switch# show int brief
Interface Vsan
08/07/03
10/25/2010 12:00:00
bootflash:///m9500-sf1ek9-mzg.2.0.0.6.bin
10/25/2020 12:00:00
0 blocks (block size 512b)
Admin Admin Status
Mode Trunk
Oper Oper Port-channel
Mode Speed
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
Configuring Interop Mode 1
313