Table of Contents
Advertisement
6 F 8 A 0 5 2 1
7. MAINTENANCE
7.1 Precautions for Maintenance, Inspection and Parts
Replacement
■Be sure to set the power
switch on the equipment to the
OFF position before doing
maintenance or inspection
inside the equipment or
DO
replacing its parts.
Failure to observe this can cause
electric shock or equipment failure.
■Do not touch the terminal
block during maintenance or
inspection. If it is necessary to
touch the terminal block, set the
power switch on the equipment
DO
to the OFF position in advance.
Failure to observe this can cause
electric shock.
Yellow
Yellow
WARNING
Yellow
The label shown at left is placed near
each terminal block on the equipment
to which power is supplied. Be careful
of electric shock.
68
■Be sure to set the power
switch on the equipment to the
OFF position before replacing
the fuse.
DO
Failure to observe this can cause
electric shock.
■Do not attempt disassemble
or modify the equipment.
Failure to observe this can cause
DON'T
electric shock or equipment
failure.
Advertisement
Table of Contents
