Table of Contents
Advertisement
Contents
[NOTE]
Do not use a transceiver, handy telephone, or other wireless device nearby.
Such a device can adversely affect correct measurement. In the event one must be
used, observe the following precautions.
(1) When using a transceiver, make sure that its output power is 5W or less.
(2) When using a transceiver or a handy telephone, keep the converter and signal
(3) Do not use a transceiver or a portable telephone nearby while the density meter
(4) Do not install the fixed antenna of a wireless device in the area around the
[NOTE]
Use a fuse of the specified rating.
A fuse other than that specified can cause density meter malfunction or breakage.
[NOTE]
Do not modify or disassemble the density meter unnecessarily. Do not use
parts other than specified.
Failure can cause malfunction and density meter fault.
[NOTE]
When moving the meter elsewhere for installation, be careful not to drop, hit,
or subject to strong shock.
Otherwise, the density meter may be broken, resulting in malfunction or fault.
[NOTE]
Before returning your meter to Toshiba for repair, etc., make sure to inform us
about the measured matter remaining in the density meter pipe, including
whether it is dangerous or not to touch the material and then clean the meter
so that no measured matter remains in its pipe.
About disposal
[NOTE]
When you dispose of this density meter, follow the ordinance or regulations of
your state.
[FCC notice]
This equipment has been tested and found to comply with the limits for a field disturbance
sensor, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, it may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures.
•
Reorient the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different fr6m' that to which the receiver
is connected.
•
Consult the dealer or an experienced radio,'1'V technician for help.
WARNING: This equipment has been certified to comply with the limits for a field disturbance
sensor, pursuant to Subpart C of part 15 FCC rules. Except AC power cable, shielded cables must be
used between the external devices and the terminals of the converter of the equipment.
Changes or modifications made to this equipment, not expressly approved by Toshiba or parties
authorized by Toshiba could void the user's authority to operate the equipment.
cable at least 30cm away from the antenna.
is in online operation. This is important to protect if from being affected by a
sudden output power change.
converter and signal cable.
9
6 F 8 A 0 5 2 1
Advertisement
Table of Contents
