Table of Contents
Advertisement
6 F 8 A 0 5 2 1
5.2.6
Measuring mode display and operating procedures
1 ： MONITORING MENU
2 ： SETTING MENU
3 ： MEASURING MODE
Move the cursor to "3" with [→] key, and press [SET] key.
[ESC]
(Previous
Menu)
OP： MEASURING MODE
DATA： CONT
[SET] CHANGE
[ESC] RETURN
5.2.7
Reading of parameters display and operating procedures
1 ： READ PARAMETERS
2 ： MEASURED VALUES
3 ： SELF-DIAGNOSIS
Move the cursor to "1" with [→] key, and press [SET] key,
and select [1 : READ PARAMETERS]
C： DENSITY MULTIPLIER
DATA： 1.000(C1)
[ESC]
[ESC] RETURN
(Previous
Menu)
[DN]
(Pre. menu)
UR:UPPER RANGE
DATA： 3.0
[ESC]
(Previous
[ESC] RETURN
Menu)
[DN]
(Pre. menu)
LR:LOWER RANGE
DATA： 0.0
[ESC]
(Previous
[ESC] RETURN
Menu)
Press the SET key to set.
Press the SET key to confirm.
Press the ESC key to cancel
[UP]
(Next menu)
[UP]
(Next menu)
[UP]
(Next menu)
OP:MEASURING MODE
RANGE :CONT/EXT
DATA :CONT
[SET] SET,[ESC]CANCEL
.
Each time the ﾟ[UP] or [DN] key is pressed, CONT/EXT are
mutually alternated thus making it possible to select an operation
mode. Select "CONT" for normal continuous operations; select
"EXT" for external synchronized operations. For details on the
external synchronized operation, refer to Section 6.7.
The set value of the density multiplier C, which is used for
density calculation, can be verified. If C2, C3 or C4 is
displayed in the parentheses, it indicates that the density
multiplier switched to by the external voltage signal (DI) is
selected.
The set value of the upper density measurement range
(the density whose current output is 20mA) can be verified.
The set value of the lower density measurement range
(the density whose current output is 4mA) can be verified.
38
Advertisement
Table of Contents
