5.2 Menus and operations
Operations should be done with five keys for setting, in combination with the LCD display.
This section shows menus and operations.
5.2.1.
Main menu
Main menu is composed of three basic menus shown below. Table 5.2.1 shows the functions of
each menu and performances when selected.
Table 5.2.1 Functions and performances of main menu
1 : MONITORING MENU
Reading of each
measuring conditions
Functions
(parameters), measured
values, and self-diagnosis
data
Measured density
Measured density
Output (4 ~ 20mA)
continuous output
LCD Density
Measured density value
display
[Measure] indicator
On
Note: "Measured density value" is output instead of "Density Test output" as the LCD density display
on the panel when "Zero calibration" or "Span calibration" is selected in the setting menu. This
arrangement is intended to compare the measured density values before and after the
calibration for both Zero and Span calibrations. As to the measured density output (4−20 mA),
"Density Test output" is used for all menu items including Zero calibration and Span calibration.
<main menu>
1 :
MONITORING MENU
2 :
SETTING MENU
3 :
MEASURING MODE
31
2 : SETTING MENU
Changing of each
measuring conditions
(parameters), zero
calibration and span
calibration
Density Test output
Density Test output
Off
6 F 8 A 0 5 2 1
3 : MEASURING MODE
Mode selection from among
two measuring modes
(operation modes) of the
normal continuous operation
and the externally
synchronized operation
Measured density continuous
output
Measured density valve
On