Toshiba LQ500 Operation Manual page 42

6 F 8 A 0 5 2 1
[DN]
(Pre. menu)
cG:RF COEF.
DATA:0.00
[ESC]
(Previous
[ESC] RETURN
Menu)
[DN] [UP]
(Pre. menu) (Next menu)
zG:ZERO RF DATA
DATA:50.00
[ESC]
(Previous
[ESC] RETURN
Menu)
[DN] [UP]
(Pre. menu) (Next menu)
ma： AVERAGING TIMES
DATA： 1
[ESC]
(Previous
[ESC] RETURN
Menu)
[DN] [UP]
(Pre. menu) (Next menu)
dx: CHANGE-RATE LIMIT
DATA： 0.00
[ESC]
(Previous
[ESC] RETURN
Menu)
[DN] [UP]
(Pre. menu) (Next menu)
HL:LIMIT TIMES
[ESC] DATA： 0
(Previous
Menu)
[ESC] RETURN
[DN] [UP]
(Pre. menu) (Next menu)
OI： OUTPUT INTERVAL
DATA： HART 0s
[ESC]
(Previous
[ESC] RETURN
Menu)
[DN]
(Pre. menu)
C： DENSITY MULTIPLIER
DATA： 1.000
[ESC]
(Previous
[ESC] RETURN
Menu)
The set value of the RF correction factor used for density
calculation can be verified. Before shipment, this value is
already set in accordance with the product's characteristics in
the shipping test. If you change this value, it will affect the
performance; therefore, normally, do not change it.
The RF data at the time of zero calibration can be verified.
The set value of the moving average times can be verified.
The variation width (%TS) permitted in the change-rate limit
function can be verified.
The times permitted in the change-rate limit function can be
verified.
Which type of communication method is selected, HART
communication
and also the output interval can be checked.
[UP]
(Next menu)
Note *1: HART protocol is set when the density meter is shipped from
Note *2: RS232C can be used by adding the data save function.
 40 
*1
or RS232C communication
the factory. In addition, 0 second appears as its output interval.
This is because the output for HART communication is
requested by the nature of this protocol from a super-ordinate
device such as the hand-held terminal AF100 and the output
interval has no meaning.
For how to switch the communication method and how to set
the output interval, refer to the LQ600 Data Save Function
*2
, can be checked