General Information; Network Settings; Radio Management Settings; Path Profile - Redline RDL-3000 Installation Manuallines

Edge
3.1

General Information

The General Information fields uniquely identify each installed system. It is
recommended to record this information prior to installation.
Setting
Name
Details
Location
Contact
3.2

Network Settings

The Edge must be assigned a unique IP addresses before it is connected to the base
station and the local area network (LAN). When DHCP is enabled, the remaining
settings are populated automatically by the DHCP server.
Setting
DHCP Enable
IP Address
Subnet Mask
Default Gateway Address
Ethernet Mode
3.3

Radio Management Settings

The following table contains the minimum set of parameters required to configure the
wireless interface.
Parameter
System Name
TCP/IP Address
Channel Size
RF Freq.
Tx Power
Antenna Gain (DFS only)

Path Profile

The path profile should include the following information:
Site Location
Antenna Height
Antenna Azimuth
Antenna Elevation
Expected RSSI
70-00204-01-01
INSTALLATION GUIDELINES
Table 5: Site Survey: General Information Settings
Radio Management
Table 6: Site Survey: Network & Syslog Server Settings
Radio Management
Table 7: Site Survey: Radio Management Settings
Value
Table 8: Site Survey: Path Profile Data
Proprietary Redline Communications © 2015 Page 20 of 56 May 19, 2015