Led Indicators; Dc Power Connections; Figure 32: Reference: Dc-Dc Poe Power Terminal Block; Table 15: Reference: Pinout For Poe And Eth Ports - Redline RDL-3000 Installation Manuallines

Edge
The following table lists the pinout for the PoE and Ethernet ports.
Pin
1, 2
3, 6
4, 5
7, 8

LED Indicators

Use the following table to determine the current mode of operation.
Mode
AF Mode
At Mode
Non
Functional

DC power Connections

The DC supply connections are located on the front panel. This is a keyed Buchanan
796864-5 (or equiv.) connector accepting 12 to 24 AWG wires. Dual isolated floating
power supply inputs are provided to accommodate deployments with backup power
(e.g., A + B battery banks). All power inputs include overvoltage and reverse polarity
protection.
Feature
+V1/-V1
+V2/-V2
GND
PWR LED
Cable Gauge
70-00204-01-01
INSTALLATION GUIDELINES
Table 14: Reference: Pinout for POE and ETH Ports
Data Pair 2
Data Pair 3
Table 15: Reference: DC-DC PoE LED Indicators
AF LED AT LED
ON OFF
Slow Blink OFF
ON ON
Slow Blink Slow Blink
Fast Blink OFF
Table 16: Reference: DC-DC PoE Power Connections
Description
Positive and negative input for primary power supply.
Positive and negative input for secondary power supply.
Common system ground. This terminal is connected directly to the
chassis and the ground lug on the back of the PoE.
LED is on when power is detected on either V1 or V2 pairs.
Power / Ground:
Chassis Ground:

Figure 32: Reference: DC-DC PoE Power Terminal Block

Proprietary Redline Communications © 2015
Description
PoE
+Ve (out)
-Ve (out)
LED Status Indication
AF Mode active (~13W) (e.g., AN-80i)
AF Mode: Over-load or short-circuit.
AT Mode active (~25W) (e.g., wireless terminal)
AT Mode: Over-load or short-circuit.
Input voltage out-of-range or
PoE over-temperature
#12 to #24 AWG
#10 Lug
Page 48 of 56
ETH
Data Pair 2
Data Pair 3
N/C
N/C
May 19, 2015