Edge
Assemble RF Port Connections
RF jumper cables (N-type connectors, 50 Ohm)
recommended to connect and weatherproof the RF cables to the wireless terminal prior
to installation on the mast (see drawing below).
Weatherproof Ethernet and Antenna Ports
When the Ethernet and RF cables are secured, all ports must be weatherproofed.
Starting as close as possible to the wireless terminal body, wrap splicing tape tightly
1.
over the bulkhead-end and work towards the cable. Stretch and wind the tape back
along the port nut. Do not leave any gaps in the coverage. It is recommended to
apply a minimum of three (3) layers of splicing tape.
Mold mastic putty tightly around the bulkhead.
2.
Wrap the entire port assembly with three (3) layers of PVC tape.
3.
Seal both ends of the assembly with cable ties to prevent unravelling of the PVC
tape. Do not over-tighten the cable ties, as this may compromise the weather seal.
This completes the weatherproofing procedure.
70-00204-01-01
INSTALLATION GUIDELINES
Proprietary Redline Communications © 2015
are included with each mounting kit. It is
Page 37 of 56
May 19, 2015