Step 5: Required Network And Wireless Settings; Step 6: Change Passwords; Table 14: Installation: Edge Parameter Settings - Redline RDL-3000 Installation Manuallines

Edge
4.2.5

Step 5: Required Network and Wireless Settings

Review and adjust the following parameters as required. Refer to the site survey
information.
Step Screen
1 Utilities
->Product
Options
2 Configuration
->System
3 Configuration
->Wireless
Notes: 1. DFS enabled systems only.
4.2.6

Step 6: Change Passwords

To ensure system security, the administrator should select the admin account and enter
a new password. User accounts should also be created to allow monitoring of the Edge
without access to configuration settings.
Important: It is difficult to restore access following a lost administrator password. It is
recommended to always record the administrator password and store this information in
a physically secure location for future reference.
70-00204-01-01
INSTALLATION GUIDELINES
Table 13: Installation: Edge Parameter Settings
Parameter
Options Key
System Name
IP Address
System Mode
Channel Width
RF Freq.
Tx Power
1
Antenna Gain
Proprietary Redline Communications © 2015
Reference Setting Value
RF Plan Enable PMP terminal (SS) mode, RF
frequency, etc.
Net. Plan Name for terminal
Net. Plan IP address for terminal
RF Plan PMP terminal
RF Plan All terminals must use the same
setting as the base station.
All terminals must use the same
RF Plan
setting as the base station.
RF Plan Refer to RF Plan
RF Plan See Mfg. Spec.
Page 35 of 56
1
May 19, 2015