201 Paper Jams - Lexmark MS310 4514-220 Service Manual

Action
Step 3
Check the main drive motor for proper operation:
a
Remove the main drive gearbox.
Note: Do not disconnect the main drive gearbox cable.
b
Perform a print job.
c
Check if the main drive motor rotates when printing.
Does it rotate when printing?
Step 4
Check the fuser gear for damage or toner contamination.
Is it free of damage and contamination?

201 paper jams

201 paper jam messages
Error code Description
201.01 Narrow media sensor is covered during warm up.
Input sensor is not covered.
201.20 Took too long to ramp up auger motor.
201.21 Stopped detecting pulses from auger motor's
encoder system.
201.22 Auger motor underspeed error.
Sensor (narrow media) jam service check
Action
Step 1
Check the narrow media sensor cable JNRW1 for proper
connection.
Is it properly connected?
Step 2
POR into the Diagnostics menu and perform a sensor test:
Diagnostics Menu > Base Sensor Test > Narrow Media
Does the sensor state on the control panel display change when
it is toggled?
Action
Go to
check" on page
Go to
page
Go to
page
Go to
page
Diagnostics and troubleshooting
98
Yes No
Go to step 4. Replace the main
drive gearbox. See
"Main drive gearbox
removal" on
page
Replace the Replace the fuser.
controller board. See See
"Controller board removal" on
removal" on page
page 210.
"Sensor (narrow media) jam service
98.
"Cartridge gearbox service check" on
133.
"Cartridge gearbox service check" on
133.
"Cartridge gearbox service check" on
133.
Yes No
Go to step 2. Reseat the cable.
Go to step 3. Replace the narrow
media sensor. See
"Narrow media/bin
full sensor removal"
on page
4514-2xx
195.
"Fuser
262.
257.