Continuous Tray 1 Duplex Print Test; Continuous Tray 2 Simplex Test; Continuous Tray 2 Duplex Print Test; Par 1 Strobe Adj - Lexmark MS310 4514-220 Service Manual

Continuous Tray 1 Duplex Print Test

This initiates a continuous tray 1 duplex print test. To stop the test, press X .

Continuous Tray 2 Simplex Test

Note: This appears only when Tray 2 is installed.
This initiates a continuous Tray 2 simplex print test. To stop the test, press X .

Continuous Tray 2 Duplex Print Test

Note: This appears only when Tray 2 is installed.
This initiates a continuous Tray 2 duplex print test. To stop the test, press X .

Par 1 Strobe Adj

This enables the user to adjust the amount of time the strobe is sampled to determine if valid data is available
on the parallel port.
Each time this value is increased by 1, the strobe is sampled 50 ns longer. Each time this value is decreased by
1, the strobe is sampled 50 ns less. When the value of this setting is 0, the factory default value is used to
determine the amount of time the strobe is sampled.

Print Event Log

This prints the Event Log. The Event Log tracks the occurrence of various critical events in the functional history
of the printer, such as paper jams and firmware updates.

Auto Dark Adj

This attempts to optimize the amount of toner used when printing with a specific operating point.
Available options:
•
Disable
•
Enable

Mark History

This places a marker at the end of the SE menu history report that indicates when the most recent crash
occurred. all crashes that occur after the history are placed after the marker.
Service menus
163
4514-2xx