Lexmark MS310 4514-220 Service Manual page 94

Error code Description
200.12 Printhead was not ready for media.
200.13 Media at input sensor is not the next media to be
imaged.
200.14 Media reached the input sensor before EP was
ready.
200.15 Input sensor covered too long. Source = [x].
200.16 Fuser motor stalled.
200.21 No response from paper port driver while waiting
for the source to deactivate the Input Source
Ready flag to indicate it has initiated picking.
200.23 Laser servo never started due to potential conflict
with the transfer servo.
200.24 Measured gap at input sensor too small to meet
video delivery requirements. (Not enough time
since prior image finished to start new image).
200.25 Input sensor covered too long. Source = [x].
200.29 Printhead drive control out of range due to an
external event beyond what the control is
designed to handle.
200.30 Invalid printhead NVRAM.
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred.
200.32 Detected cover switch bounce.
200.33 Input sensor covered too quickly.
200.38 Interpage servo gap smaller than expected for
galvo offset target evaluation.
200.42 Rogue sheet at ACM sensor while flushing the
paper path prior to declaring tray 1 source empty.
200.44 Page from tray 1 did not reach the input sensor (or
the manual feed sensor, if present) after multiple
pick attempts. Page did make it out of the tray at
least as far as the ACM sensor.
200.84 Image data did not start on time.
200.87 During warm up flush, sheet detected too long
over input sensor.
Action
Go to
page
Go to
page
Go to
page
Go to
check" on page
Go to
check" on page
Go to
check" on page
Go to
page
Go to
page
Go to
check" on page
Go to
page
Go to
page
Go to
check" on page
Go to
check" on page
Go to
check" on page
Go to
check" on page
Go to
check" on page
Go to
check" on page
Go to
page
Go to
check" on page
Diagnostics and troubleshooting
94
"Sensor (input) jam service check" on
97.
"Sensor (input) jam service check" on
97.
"Sensor (input) jam service check" on
97.
"Sensor (input) early/late arriving service
95.
"Main drive motor control jam service
97.
"Sensor (input) early/late arriving service
95.
"Sensor (input) jam service check" on
97.
"Sensor (input) jam service check" on
97.
"Sensor (input) early/late arriving service
95.
"Sensor (input) jam service check" on
97.
"Sensor (input) jam service check" on
97.
"Sensor (input) early/late arriving service
95.
"Sensor (input) early/late arriving service
95.
"Sensor (input) early/late arriving service
95.
"Sensor (input) early/late arriving service
95.
"Sensor (input) early/late arriving service
95.
"Sensor (input) early/late arriving service
95.
"Sensor (input) jam service check" on
97.
"Sensor (input) early/late arriving service
95.
4514-2xx