201 Paper Jams - Lexmark MS410 Series Service Manual

Action
Step 2
a
Remove the main drive gearbox.
b
Check the gears of main drive gearbox for wear or damage.
Are they free of wear or damage?
Step 3
Check the main drive motor for proper operation:
a
Remove the main drive gearbox.
Note: Do not disconnect the main drive gearbox cable.
b
POR into the Diagnostics menu and perform a feed test:
Diagnostics menu > Input Tray Tests > Feed Test >
Select any input source
c
Check if the main drive motor rotates when doing the feed test.
Does it rotate when doing the feed test?
Step 4
Check the fuser gear for damage or toner contamination.
Is it free of damage and contamination?

201 paper jams

Jam, standard bin [20y.xx]
1
Firmly grasp the jammed paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
2
From the printer control panel, press
201 paper jam messages
Error code Description
201.01 Narrow media sensor is covered during warm up.
Input sensor is not covered.
Yes
Go to step 3.
Go to step 4.
Replace the controller
board. See
board removal" on
page
to clear the message and continue printing.
Action
Go to
page 57.
Diagnostic information
56
No
Replace the main drive
gearbox. See
drive gearbox
removal" on page
147.
Replace the main drive
gearbox. See
drive gearbox
removal" on page
147.
Replace the fuser. See
"Controller "Fuser removal" on
page
164.
"Sensor (narrow media) jam service check" on
4514-420, -430
"Main
"Main
211.