Removal Procedures - Lexmark MS310 4514-220 Service Manual

3
Fold a second vertical fold near the center so that the left side top edge aligns with the right side top edge.
4
If the grid lines of the right flap align below the corresponding lines on the left flap, then adjust the printhead
clockwise relative to the printer, and recheck. If the grid lines of the left flap align below the corresponding
lines of the right side, then adjust the printhead counterclockwise.
5
Print again a Quick test page, and check if adjustments are still needed.
6
After obtaining a properly adjusted image on the paper, tighten all the screws.

Removal procedures

Keep the following tips in mind as you replace parts:
•
Some removal procedures require removing cable ties. You must replace cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
•
Remove the toner cartridges, imaging unit, and media tray before removing other printer parts. The imaging
unit should be carefully set on a clean, smooth, and flat surface. It should also be protected from light while
out of the device.
•
Disconnect all external cables from the printer to prevent possible damage during service.
Parts removal
193
4514-2xx