Dc To Ac Inverter (If Equipped); Inverter Location On Machine - JLG 1932RS/6RS Service And Maintenance Manual

Excessive Battery Watering Requirements or Strong
Sulphur (Rotten Egg) Smell
These symptoms indicate over-charging or high battery tem-
perature. These symptoms are unlikely to be caused by too
high a charge current since the maximum charge current of
the charger will be small compared to even a moderately sized
battery pack. The most likely cause for this problem is incor-
rect charge algorithm setting and/or high ambient tempera-
tures. For correct charge algorithm setting, refer www.jlg.com
for below supplement manual
• TROUBLESHOOTING GUIDE - PN 3128829
3121273
SECTION 3 - CHASSIS & SCISSOR ARMS

3.5 DC TO AC INVERTER (IF EQUIPPED)

Inverter Location on Machine

The inverter is located to the right rear of the machine in the
battery side compartment on all RS Scissor models.
11
9
10
8
7
1. DC to AC Inverter
2. Overload LED Indicator
3. Inverter Internal ON/OFF
Switch - Set to ON from fac-
tory
4. Inverter VAC Output Cord
5. To Inverter ON/OFF Switch at
Ground Control Panel
Figure 3-7. DC to AC Inverter Components
* Items located under shield.
2
1. Inverter On/Off Switch
Figure 3-8. Inverter On/Off Switch Location
1
2
3
4
6
5
6. Inverter Power Relay
7. From VDC Battery POS (+)
8. To VDC Inverter POS (+) Input
9. External DC 25A Replaceable
Fuse(s)*
10. From VDC Battery NEG (–)*
11. Inverter Cooling Fan*
1
10 01
14 30
O F F 10 A
O N
I N V E
R T E
R
2. Ground Control Panel
3-7